SE40555

15W LED Driver with 6 Port JB4 Distributor

SE40555

15W LED Driver with 6 Port JB4 Distributor

Use this driver to run any GREEN colour coded products up to a maximum wattage of 15W.

This electronic LED converter is exclusively designed for LED products which are to be used indoors. The electronic converter has a switch mode power supply with 24VDC constant output voltage.

An electronic protection circuit switches off the electronic converter in case of short circuit or overload in the secondary circuit, overheat as well as open circuit. This convertor is a thermally protected device, the type of protection is automatic resetting. After removing the faults, the electronic LED converter is ready for operation again.

Priporočena lokacija

Description

Use this driver to run any GREEN colour coded products up to a maximum wattage of 15W.

This electronic LED converter is exclusively designed for LED products which are to be used indoors. The electronic converter has a switch mode power supply with 24VDC constant output voltage.

An electronic protection circuit switches off the electronic converter in case of short circuit or overload in the secondary circuit, overheat as well as open circuit. This convertor is a thermally protected device, the type of protection is automatic resetting. After removing the faults, the electronic LED converter is ready for operation again.

Možnosti naročanja
Možnosti naročanja
 Kataloška številkaTransformatorkategorijaMočStockRRPQty
SE40555ZelenaA15WIn Stock£23.04
Opis izdelka
Opis izdelka
  • Dolžina kabla1,5 metra

    Namig

Ključne točke

>  The unit conforms to the directive 2004/108/EC for the electromagnetic compatibility and the low voltage directive 2006/95/EC.
>  The electronic converter can only be used with the LED lamps.
>  The electronic converter is only suitable for use in indoors. Protect the electronic converter against excessive heat (permissible operating temperature range –20 to +40 degrees celcius).
>  The loads indicated on the converter must neither exceed nor below the following values: 0.5-15W
>  Connect the LED lamps to the electronic LED converter with correct polarity according to the schematic drawing.
>  The maximum length of the output cable to the LED lamps should not exceed 8m in order to meet the EMC standard.
>  If the electronic LED converter is used for purposes other than originally intended or it is connected in the wrong way, no liability can be taken over for possible damages.



Specifications:

Input voltage: 220-240V~ 50Hz
Output voltage: 24VDC +/-0.5V
Rated power: 15W
Minimum Load: 0.5W
Protection degree: IP20

Dimensions:

Length: 120mm
Width: 45mm
Depth: 17mm

Najbolj pogosta vprašanja o izdelku
Najbolj pogosta vprašanja o izdelku

What is the length of the cable between the driver and the distribution block?

140mm

Can our products be used with those of other manufacturers?

We have not tested this so therefore do not recommend it.

Prenos
Prenos
Dodatki
Dodatki
x

Delite moč transformatorja z močjo ene luči, ki jo želite priključiti in dobili boste število luči, ki jih lahko priključite na en transformator

Primer: 15W transformator s 3W lučmi 15 ÷ 3 = 5 luči

Transformatorji so na voljo v različnih izvedbah. Izbira transformatorja je odvisna od števila luči, ki jih želite priključiti.

Transformatorji imajo omejeno število vhodov na priklopnem razdelilcu. Priklopni razdelilec s 6 vrati omogoča priklop največ 6 luči.

Pri izbiri je potrebno upoštevati tako skupno moč luči, kakor tudi število vhodov na priklopnem razdelilcu