SE40516.1

Cannon Cabinet/Swipe Sensor Switch

SE40516.1

Cannon Cabinet/Swipe Sensor Switch

This attractive IR sensor has 3 functions; use under cabinets as a swipe on/off switch or to dim the connected lights. Alternatively, mount inside a kitchen cabinet or wardrobe to act as a door sensor to internal lights.

Please note this .1 code product has been upgraded to now include a dimming function and to accommodate products with higher wattages.

Priporočena lokacija

Description

This attractive IR sensor has 3 functions; use under cabinets as a swipe on/off switch or to dim the connected lights. Alternatively, mount inside a kitchen cabinet or wardrobe to act as a door sensor to internal lights.

Please note this .1 code product has been upgraded to now include a dimming function and to accommodate products with higher wattages.

Možnosti naročanja
Možnosti naročanja
 Kataloška številkaTransformatorkategorijaSenzorStockRRPQty
SE40516.1Zelena, modraBDaIn Stock£20.16
Opis izdelka
Opis izdelka
  • Dolžina kabla2.5 metra

    Namig

Ključne točke

 > Activates and dims lights with motion.

Three functions:

> Mount inside a cabinet - open door to activate light.

> Mount under cabinet - swipe hand in detection range to activate light. Dimming function is available in this mode.
.
> Mount under cabinet - dim the lights when hand is held under the sensor for more than 1 second.

> 5cm detection range.

> Plug and play solution.

> Can be surface mounted or recessed.

> Pre-set to monostable function.

> 1 x JB4 Distribution Block supplied with each sensor.

> 2.5m cable from Sensor to Distribution Block.

> Works with any 12V or 24V product.

> Silver finish.

Najbolj pogosta vprašanja o izdelku
Najbolj pogosta vprašanja o izdelku

Does 'boxing in' the receiver affect the detection range of the remote control?

It depends on the material which the receiver is positioned behind. Wood for example does not affect the detection range, however metal will reduce the detection range to a degree. The detection range will also be affected if enclosed within a wall.

How many sensors can be used on one driver?

Sensors do not have their own wattage, therefore any amount of sensors can be used until they fill up the ports of the driver. The amount of lights that can be used on one driver is dependant upon the wattage of the lights and the wattage of the driver. To work out how many lights can be used on one driver divide the wattage of the driver by the wattage of the lights. A 24W (12V) driver used with the sensor will be maxed out one 24W has been used up.

Can you use 2 sensors on one light?

Yes.

Can sensors be used in the bathroom?

No. Our sensors are not IP rated so therefore they need to be installed outside the bathroom.

Can our products be used with those of other manufacturers?

We have not tested this so therefore do not recommend it.

Oglejte si še več najbolj pogostih vprašanj (3)
Prenos
Prenos
x

Delite moč transformatorja z močjo ene luči, ki jo želite priključiti in dobili boste število luči, ki jih lahko priključite na en transformator

Primer: 15W transformator s 3W lučmi 15 ÷ 3 = 5 luči

Transformatorji so na voljo v različnih izvedbah. Izbira transformatorja je odvisna od števila luči, ki jih želite priključiti.

Transformatorji imajo omejeno število vhodov na priklopnem razdelilcu. Priklopni razdelilec s 6 vrati omogoča priklop največ 6 luči.

Pri izbiri je potrebno upoštevati tako skupno moč luči, kakor tudi število vhodov na priklopnem razdelilcu